Notifications
Clear all
synchro
Skupina: Registrovaný
Přidal se: 2024/02/09
Active Member
1
| I will give this a try. Thank you! | před 2 years | |
| Agreed. I use that to get most of the support 1st layer off.... | před 2 years | |
| Since posting, I did another print, and the same happened wi... | před 2 years | |
| I tried that and had no luck. The problem is only where the ... | před 2 years | |
| I tried all of these to no avail. I ended up taking my wife'... | před 2 years | |
| Getting PETG off Satin build plate | před 2 years |