|
what about the tension? When it's printing, can you just pul... In forum How do I print this? (Printing help) |
9 months ago |
|
Ninjatek Edge on my MK4 with .4 nozzle. Trying to track down... In forum How do I print this? (Printing help) |
9 months ago |
|
At what point does it again check tension?
Seems that if I ... In forum Assembly and first prints troubleshooting |
7 years ago |
|
I slowed infill down the 45mm/s and that resolved the issue.... In forum Others (Archive) |
7 years ago |
|
Slow down the infill speed a little bit works well for me.
... In forum Others (Archive) |
7 years ago |
|
I am printing and testing different infill patterns and came... In forum Others (Archive) |
7 years ago |
|
PETG and renticular fill In forum Others (Archive) |
7 years ago |
|
What is the number? Some tension, frequency? (My book only h... In forum Others (Archive) |
7 years ago |
|
I made the mistake of starting an 11 hour print BEFORE upgra... In forum Others (Archive) |
7 years ago |
|
My guess would be that the retraction settings are inaccurat... In forum Others (Archive) |
7 years ago |
|
With RC5, I did not have infill problems with 15% honeycomb ... In forum Others (Archive) |
7 years ago |
|
My guess would be that the retraction settings are inaccurat... In forum Others (Archive) |
7 years ago |
|
Are you running the same speeds as RC4? RC5 disabled Linear ... In forum Others (Archive) |
7 years ago |
|
New firmware print issues with Infill In forum Others (Archive) |
7 years ago |
|
Im using a hardend steel nozzle from E3D, i cannot see any d... In forum Others (Archive) |
7 years ago |
|
also have to be careful how much you tighten it.
They su... In forum Others (Archive) |
7 years ago |
|
320 mm.
That, I had to look at my Misumi order
PSFJ8-320/330... In forum Others (Archive) |
7 years ago |
|
I was able to print PETG without any problem until the FW/SW... In forum Others (Archive) |
7 years ago |
|
That is how it fit when I put the hot end in on my parts as ... In forum Others (Archive) |
7 years ago |
