|
So this is what I have now. I still wish I could rename the ... Im Forum PrusaSlicer |
Vor 4 months |
|
@Neophyl, double-clicking does not appear to work for me. I'... Im Forum PrusaSlicer |
Vor 4 months |
|
Rename modifiers? Im Forum PrusaSlicer |
Vor 4 months |
|
Micro update: That must have been the problem, because since... Im Forum Hardware, firmware and software help |
Vor 7 years |
|
Thanks, all. After a lot of checking and double-checking, an... Im Forum Hardware, firmware and software help |
Vor 7 years |
|
That I was not aware of, thank you. Will investigate. Im Forum Hardware, firmware and software help |
Vor 7 years |
|
I'm not rejecting your help — I'm just saying that what you ... Im Forum Hardware, firmware and software help |
Vor 7 years |
|
lower the extruder by increasing the negative live Z value, ... Im Forum Hardware, firmware and software help |
Vor 7 years |
|
Thanks, but that’s not the problem. The problem is the heigh... Im Forum Hardware, firmware and software help |
Vor 7 years |
|
Addendum: based on further observation, I don't think this e... Im Forum Hardware, firmware and software help |
Vor 7 years |
|
Inconsistent first layer based on X-axis direction Im Forum Hardware, firmware and software help |
Vor 7 years |
|
I seemed to have reached a happy medium again. It seems the ... Im Forum Hardware, firmware and software help |
Vor 7 years |
|
Does your idler spin (very) freely if you flick it? Even wit... Im Forum Hardware, firmware and software help |
Vor 7 years |
