|
So this is what I have now. I still wish I could rename the ... In forum PrusaSlicer |
4 months ago |
|
@Neophyl, double-clicking does not appear to work for me. I'... In forum PrusaSlicer |
4 months ago |
|
Rename modifiers? In forum PrusaSlicer |
4 months ago |
|
Micro update: That must have been the problem, because since... In forum Hardware, firmware and software help |
7 years ago |
|
Thanks, all. After a lot of checking and double-checking, an... In forum Hardware, firmware and software help |
7 years ago |
|
That I was not aware of, thank you. Will investigate. In forum Hardware, firmware and software help |
7 years ago |
|
I'm not rejecting your help — I'm just saying that what you ... In forum Hardware, firmware and software help |
7 years ago |
|
lower the extruder by increasing the negative live Z value, ... In forum Hardware, firmware and software help |
7 years ago |
|
Thanks, but that’s not the problem. The problem is the heigh... In forum Hardware, firmware and software help |
7 years ago |
|
Addendum: based on further observation, I don't think this e... In forum Hardware, firmware and software help |
7 years ago |
|
Inconsistent first layer based on X-axis direction In forum Hardware, firmware and software help |
7 years ago |
|
I seemed to have reached a happy medium again. It seems the ... In forum Hardware, firmware and software help |
7 years ago |
|
Does your idler spin (very) freely if you flick it? Even wit... In forum Hardware, firmware and software help |
7 years ago |
