Notifications
Clear all
svachalek
Skupina: Registrovaný
Přidal se: 2018/09/08
Active Member
1
| It got between the PINDA and the heater block. That part of ... | před 6 years | |
| Broken PINDA? | před 6 years | |
| Absolutely. Even better if they can do free shipping through... | před 6 years | |
| That looks WAY too tight. The nuts should go in the little ... | před 6 years | |
| Turns out the gears on the extruder were a bit too tight and... | před 6 years | |
| Yeah, the bad side was down. After beating my head against ... | před 6 years | |
| Extrusion problem? | před 6 years | |
| Update: I got the trapezoid nuts and some acetone tonight an... | před 6 years | |
| The rings around the top and bottom are because it's printin... | před 6 years | |
| I just built my first printer a week ago so I'm no expert bu... | před 6 years | |
| Thanks for that bit of reassurance. I thought of one other t... | před 6 years | |
| Major adhesion problems after changing nozzle | před 6 years |