|
I have been printing a whole spool of Hobbyking PETG and som... In forum Others (Archive) |
7 years ago |
|
Just had similar experience. Duplicated settings as best I c... In forum Others (Archive) |
7 years ago |
|
Time for an update!
I did a 20 hour print of the Makerbot T... In forum Others (Archive) |
7 years ago |
|
I have been printing over 1kg of PETG without ANY issues, an... In forum Others (Archive) |
7 years ago |
|
I tested 2 filaments over the weekend, a semiflex and NinjaF... In forum Others (Archive) |
7 years ago |
|
GREAT! Thank you! That's the most comprehensive settings pos... In forum Others (Archive) |
7 years ago |
|
I printed ninjaflex with no issues. Printed a nice frog jus... In forum Others (Archive) |
7 years ago |
|
I am not sure if I understand your first post correctly, jus... In forum Others (Archive) |
7 years ago |
|
I have funny first layer recently, too. It's only first laye... In forum Others (Archive) |
7 years ago |
|
I have not yet tried to print PC-Max but I am very intereste... In forum Others (Archive) |
7 years ago |
|
Scott, as Martin said, if you are technically minded, go wit... In forum Others (Archive) |
7 years ago |
|
Bondtech's assembly documentation shows you should add lubri... In forum Others (Archive) |
7 years ago |
|
Was looking for Misumi, but not available in EU for non-comm... In forum Others (Archive) |
7 years ago |
|
I had the issue as well a few times with PETG, but not every... In forum Others (Archive) |
7 years ago |
|
I built my MK3 in december and installed high quality rods a... In forum Others (Archive) |
7 years ago |
|
Sure, we can hack together any kind of profile we want on ou... In forum Others (Archive) |
7 years ago |
|
It's surprising to hear about your issues of getting PETG to... In forum Others (Archive) |
7 years ago |
|
Ultem is extremely demanding to print, and only some special... In forum Others (Archive) |
7 years ago |
|
Take a look at this thread: In forum Others (Archive) |
7 years ago |
|
Hi Georg,
yes I just learned the hard way that the model i... In forum Others (Archive) |
7 years ago |
