Notifications
Clear all
surfgeorge
surfgeorge
Group: Registered
Joined: 2017/09/10
Estimable Member
4
I have been printing a whole spool of Hobbyking PETG and som...

In forum Others (Archive)

7 years ago
Just had similar experience. Duplicated settings as best I c...

In forum Others (Archive)

7 years ago
Time for an update! I did a 20 hour print of the Makerbot T...

In forum Others (Archive)

7 years ago
I have been printing over 1kg of PETG without ANY issues, an...

In forum Others (Archive)

7 years ago
I tested 2 filaments over the weekend, a semiflex and NinjaF...

In forum Others (Archive)

7 years ago
GREAT! Thank you! That's the most comprehensive settings pos...

In forum Others (Archive)

7 years ago
I printed ninjaflex with no issues. Printed a nice frog jus...

In forum Others (Archive)

7 years ago
I am not sure if I understand your first post correctly, jus...

In forum Others (Archive)

7 years ago
I have funny first layer recently, too. It's only first laye...

In forum Others (Archive)

7 years ago
I have not yet tried to print PC-Max but I am very intereste...

In forum Others (Archive)

7 years ago
Scott, as Martin said, if you are technically minded, go wit...

In forum Others (Archive)

7 years ago
Bondtech's assembly documentation shows you should add lubri...

In forum Others (Archive)

7 years ago
Was looking for Misumi, but not available in EU for non-comm...

In forum Others (Archive)

7 years ago
I had the issue as well a few times with PETG, but not every...

In forum Others (Archive)

7 years ago
I built my MK3 in december and installed high quality rods a...

In forum Others (Archive)

7 years ago
Sure, we can hack together any kind of profile we want on ou...

In forum Others (Archive)

7 years ago
It's surprising to hear about your issues of getting PETG to...

In forum Others (Archive)

7 years ago
Ultem is extremely demanding to print, and only some special...

In forum Others (Archive)

7 years ago
Take a look at this thread:

In forum Others (Archive)

7 years ago
Hi Georg, yes I just learned the hard way that the model i...

In forum Others (Archive)

7 years ago
Page 9 / 13
Share: