Prusa3D Forum

Notifications

Clear all

Struttmann

Groupe: Enregistré

A(ont) rejoint: 2026/02/05

Active Member

	Thanks, for these. However, changing from PETG to PLA was j... Dans le forum Hardware, firmware and software help	il y a 2 months
	Manually Change the Filament Type That the Printer Thinks Th... Dans le forum Hardware, firmware and software help	il y a 2 months
	I submit that there is a third scenario: Removing and insert... Dans le forum Hardware, firmware and software help	il y a 2 months
	Even after grounding all of my steppers, I had another crash... Dans le forum Hardware, firmware and software help	il y a 2 months
	This is similar to the issue discussed here:/p> Dans le forum Hardware, firmware and software help	il y a 3 months
	Thanks for posting this (especially the photo). I just appli... Dans le forum Hardware, firmware and software help	il y a 3 months
	Are the holes in the stepper mounting plate threaded? I'm th... Dans le forum Hardware, firmware and software help	il y a 3 months
	I, too, have experienced the crash/restart upon inserting or... Dans le forum Hardware, firmware and software help	il y a 3 months

Statistiques du forum

598 Forums

71.4 K Sujets

501.4 K Messages

12 En-ligne

82.3 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé