Notifications
Clear all
Strider
Groupe: Enregistré
A(ont) rejoint: 2023/11/16
Active Member
1
|
I was focusing primarily on PLA which is good below 40% and ... Dans le forum Hardware, firmware and software help |
il y a 7 months | |
|
Thaoks, I have my filaments and printers in a controlled env... Dans le forum Hardware, firmware and software help |
il y a 7 months | |
|
Okay, using pliars on the boden tube (which I was very uncom... Dans le forum Hardware, firmware and software help |
il y a 7 months | |
|
Stuck on removing filament from bowden tube Dans le forum Hardware, firmware and software help |
il y a 7 months | |
|
Problem seems to have eventually resolved itself without any... Dans le forum PrusaSlicer |
il y a 2 years | |
|
Export G-Code - Rename or Change Location Dans le forum PrusaSlicer |
il y a 2 years |