|
Yeah the magnets are ok. The sensor used to work in the begi... In forum Hardware, firmware and software help |
5 years temu |
|
Thank you both for the feedback! Based on your suggestions, ... In forum Hardware, firmware and software help |
5 years temu |
|
Thank you for the response!! I did not think to check verbos... In forum Hardware, firmware and software help |
5 years temu |
|
Octoprint + Runout Sensor MK3S In forum Hardware, firmware and software help |
5 years temu |
|
Thank you for the response! It doesn't bug me at all. I was ... In forum Hardware, firmware and software help |
5 years temu |
|
Bed Heater audible "clicking" new FW 3.7.1 In forum Hardware, firmware and software help |
5 years temu |
|
No i ordered and got the 3S. But my understanding was that t... In forum Hardware, firmware and software help |
6 years temu |
|
Gitcha. Thanks for the clarification. It's disappointing sin... In forum Hardware, firmware and software help |
6 years temu |
|
So it never worked or what? I've seen the post where it's ad... In forum Hardware, firmware and software help |
6 years temu |
|
Filament stuck detection working? In forum Hardware, firmware and software help |
6 years temu |
