Prusa3D Forum

Notifications

Clear all

Stone Age Sculptor

Groupe: Enregistré

A(ont) rejoint: 2024/01/20

Active Member

	Thank you. Yes, one of the screws in the hotend was missing.... Dans le forum Hardware, firmware and software help	il y a 2 months
	A screw fell out of my print head Dans le forum Hardware, firmware and software help	il y a 2 months
	Thank you!With Paint-on supports and your settings for the s... Dans le forum PrusaSlicer	il y a 3 months
	The zip file is attached. It is not printed in one go, I pri... Dans le forum PrusaSlicer	il y a 3 months
	Support is too wide for a hole in a thin wall. Dans le forum PrusaSlicer	il y a 3 months
	Thank you. That is a lot of work when I want to make a numbe... Dans le forum PrusaSlicer	il y a 10 months
	Thank you. Yes, that is my problem. I didn't know that it wa... Dans le forum PrusaSlicer	il y a 10 months
	That makes no difference. I have a single extruder and I use... Dans le forum PrusaSlicer	il y a 10 months
	Here are a few pictures. The first picture is the logo tha... Dans le forum PrusaSlicer	il y a 10 months
	Can not find right settings for a 2D logo. Dans le forum PrusaSlicer	il y a 10 months

Statistiques du forum

559 Forums

63.1 K Sujets

444 K Messages

21 En-ligne

68 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé