Notifications
Clear all
stijn.d3
Skupina: Registrovaný
Přidal se: 2017/11/10
Active Member
1
|
raspberry pi zero 40-pin GPIO header In forum Others (Archive) |
před 7 years | |
|
Do you find a profile yet? I never liked the slic3r interfac... In forum Others (Archive) |
před 7 years | |
|
I have the same problem with my printer. Today printed a 130... In forum Others (Archive) |
před 7 years | |
|
I can confirm that the orange petg is not the correct one. I... In forum Others (Archive) |
před 7 years | |
|
Hi
I had the same problem 2 years ago when I first uses e3... In forum Others (Archive) |
před 7 years | |
|
Oke i had a look in the manual
First of all i think the cli... In forum Others (Archive) |
před 7 years | |
|
Hi there
My idee for the bad surface is the layer height li... In forum Others (Archive) |
před 7 years | |
| The sound is defenetly from the filament. I had this also so... | před 7 years | |
|
Hi
I had the same with a non prusa style printer. I was lo... In forum Others (Archive) |
před 7 years |