Prusa3D Forum

Notifications

Clear all

Steve Weathernam

Groupe: Enregistré

A(ont) rejoint: 2024/10/27

Active Member

	exactly what I'm thinking. Too much work for 10%. Dans le forum PrusaSlicer	il y a 4 months
	Oh, BTW, Stefan only got about a 10% improvement in strength... Dans le forum PrusaSlicer	il y a 4 months
	Can't disagree with anything you say. Mostly I wanted to try... Dans le forum PrusaSlicer	il y a 4 months
	OK, I'm a little surprised there's been so little interest. ... Dans le forum PrusaSlicer	il y a 4 months
	Brick Layers Dans le forum PrusaSlicer	il y a 4 months
	I also noticed something else. If a file that has a % charac... Dans le forum Introduction & Instructions	il y a 10 months
	I ran into this recently too. I would try to upload a file t... Dans le forum Introduction & Instructions	il y a 10 months
	Things like this are why I never mix filament types in nozzl... Dans le forum Hardware, firmware and software help	il y a 10 months
	In my case what happened is that the filament went down the ... Dans le forum Hardware, firmware and software help	il y a 11 months
	Thank you for creating this mod. I won't be using it yet. I ... Dans le forum Hardware, firmware and software help	il y a 11 months
	Just wanted to add another possible cause to the mix. I was ... Dans le forum Hardware, firmware and software help	il y a 11 months

Statistiques du forum

585 Forums

68.2 K Sujets

477.9 K Messages

11 En-ligne

75.9 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé