Čeština
Fóra
Uživatelé
steve.a
Aktivita
 
Notifications
Clear all
steve.a
steve.a
Skupina: Registrovaný
Přidal se: 2016/04/18
Eminent Member
2
Profile Aktivita
Thanks for the suggestions. I remembered re-assembling the f...

In forum Prusa i3 kit (Archive)

 před 8 years
Cooling fan requires help to start spinning

In forum Prusa i3 kit (Archive)

 před 8 years
Thanks Peter that exactly what I needed Cheers Steve

In forum Prusa i3 kit (Archive)

 před 8 years
Hi Peter Ok firmware changes sound a bit scary. Any idea wha...

In forum Prusa i3 kit (Archive)

 před 8 years
Ok so if I measure resistance with the multimeter across the...

In forum Prusa i3 kit (Archive)

 před 8 years
X End Stop Broken?

In forum Prusa i3 kit (Archive)

 před 8 years
Hi Peter, Yes I agree. I replace the tie and it quickly loos...

In forum Improvements (Archive)

 před 8 years
Improved x endstop

In forum Improvements (Archive)

 před 8 years
Thanks Joan! I guess I should be paying more attention to wh...

In forum Others (Archive)

 před 8 years
Nozzle screw thread snapped off in hotend

In forum Others (Archive)

 před 8 years
Hi All, Thanks for the helpful replies 🙂 Yes I ended up tur...

In forum Prusa i3 kit (Archive)

 před 9 years
Glass print surface broken after 2 months

In forum Prusa i3 kit (Archive)

 před 9 years
Im using Sainsmart HIPS 1.75mm Orange. If anyone has been ab...

In forum Print tips (Archive)

 před 9 years
Hi Nigel, Thanks but from what I read its also used to prin...

In forum Print tips (Archive)

 před 9 years
I went back to Tree frog printing as its much less time cons...

In forum Print tips (Archive)

 před 9 years
Layer seperation in HIPS print

In forum Print tips (Archive)

 před 9 years
Settings > Preheat > Cool down

In forum Prusa i3 kit (Archive)

 před 9 years
Peter/Christophe Ah awesome thanks for the advice! I've onl...

In forum Prusa i3 kit (Archive)

 před 9 years
Peter, Thanks for the pic. Yes thats what I have at the mom...

In forum Prusa i3 kit (Archive)

 před 9 years
Thanks Peter. Er where abouts do I do this? By editing the ...

In forum Prusa i3 kit (Archive)

 před 9 years
Stránka 1 / 2
Share: