Notifications
Clear all
Stefan
Skupina: Registrovaný
Přidal se: 2018/02/18
Active Member
1
|
Is it possible to increase fanspeed while ironing? In forum PrusaSlicer |
před 4 years | |
|
@neophyl I use the 3.9.0 RC1 firmware on my MK2.5s. I did so... In forum PrusaSlicer |
před 5 years | |
|
@inf-93 Just flush Your printer with Firmware 3.9.0 RC1. Thi... In forum PrusaSlicer |
před 5 years | |
|
Break do not resume print In forum PrusaSlicer |
před 5 years | |
|
break will not resume print In forum PrusaSlicer |
před 5 years | |
|
@billcampbell Hello, if You want to aline a modifer or a par... In forum PrusaSlicer |
před 5 years | |
|
Hello Neophyl, thank You for your reply and reporting on Git... In forum PrusaSlicer |
před 5 years | |
|
Moving modifers to "0" In forum PrusaSlicer |
před 5 years |