|
Something I noticed in the picture you supplied is the Extru... Nel forum Others (Archive) |
8 years fa |
|
Well, the clicking noise is most likely the extruder gear tr... Nel forum Others (Archive) |
8 years fa |
|
Agreed, unless it needs to be moved, best to keep from movin... Nel forum Print tips (Archive) |
8 years fa |
|
Strange, I use Hatchbox Red PLA and haven't had that issue. ... Nel forum Print tips (Archive) |
8 years fa |
|
ABS you will normally need to lower your Live-Z by another .... Nel forum Print tips (Archive) |
8 years fa |
|
That looks like your nozzle is just a hair too close to the ... Nel forum Print tips (Archive) |
8 years fa |
|
Same here... read the 3.0.10 notes and it was supposed to fi... Nel forum Prusa i3 kit (Archive) |
8 years fa |
|
I hear ya, I've experience the nozzle going into the bed and... Nel forum Software (Archive) |
8 years fa |
|
The way that I set my PINDA is to turn the unit off and manu... Nel forum Prusa i3 kit (Archive) |
8 years fa |
|
On mine, the threaded Z-axis rods are out about 1-2mm above ... Nel forum Others (Archive) |
8 years fa |
|
The problem with the current iteration of the ColorChange is... Nel forum Software (Archive) |
8 years fa |
|
The PEI on the bed doesn't need any special treatment. I use... Nel forum Others (Archive) |
8 years fa |
|
Check out my post here:
The manual has the bug, not the f... Nel forum Prusa i3 kit (Archive) |
8 years fa |
|
Don't have to worry about the Rambo case, it doesn't attach ... Nel forum Others (Archive) |
8 years fa |
|
Also, don't forget about doing the Bed Leveling calibrations... Nel forum Prusa i3 kit (Archive) |
8 years fa |
|
I switch between ABS and PLA often and do not have an enclos... Nel forum Others (Archive) |
8 years fa |
|
If all you are having is a wiring issue due to a broken wire... Nel forum Others (Archive) |
8 years fa |
|
Not sure if you have played with the Server part yet, but so... Nel forum Print tips (Archive) |
8 years fa |
|
Not recommended to not have the PSU attached to the unit. Th... Nel forum Others (Archive) |
8 years fa |
|
That picture looks much better. Your previous one was showin... Nel forum Print tips (Archive) |
8 years fa |
