Starlynk – Activity – Prusa3D Forum

Notifications

Clear all

Starlynk

Group: Registered

Joined: 2017/02/10

Trusted Member

	Thanks! It fixed the M110 and I'm up and running again. In forum Software (Archive)	8 years ago
	Yeah, not sure if you get what I get, but its just Com1 and ... In forum Others (Archive)	8 years ago
	Yup, I have the most recent version. I am guessing that sinc... In forum Software (Archive)	8 years ago
	Same here with problems after updating firmware. I am using... In forum Software (Archive)	8 years ago
	Linear Advance - Slic3r PE In forum Software (Archive)	8 years ago
	I've used the wood, and yes, it does get a bit stringy. Howe... In forum Awesome prints (Hall Of Fame)	8 years ago
	I haven't used eSun PLA+, but it shouldn't be much different... In forum Others (Archive)	8 years ago
	May not be the slicer program. I would check your model and ... In forum Print tips (Archive)	8 years ago
	What temperature are you heating the bed to when using ABS? ... In forum Others (Archive)	8 years ago
	Looking at the images from the tubes and the headphone rest,... In forum Others (Archive)	8 years ago
	Its not uncommon for PEI to sink/rise in areas after a print... In forum Prusa i3 kit (Archive)	8 years ago
	1 full turn of the PINDA is 1mm according to Prusa. I recomm... In forum Prusa i3 kit (Archive)	8 years ago
	Spiral Vase mode only works with a single wall thickness. Lo... In forum Print tips (Archive)	8 years ago
	Looks like your not extracting enough when you lowered the v... In forum Print tips (Archive)	8 years ago
	I recently found out that I have had to use auto cooling wit... In forum Print tips (Archive)	8 years ago
	Not really sure that Slicer PE would be the right place to a... In forum Software (Archive)	8 years ago
	Apparently left side was really not pushed in enough. Yet it... In forum Prusa i3 kit (Archive)	8 years ago
	Just an FYI when you do the calibration for bed leveling. Fi... In forum Prusa i3 kit (Archive)	8 years ago
	Blue paper towels from Costco (Or equivalent) is what I use.... In forum Prusa i3 kit (Archive)	8 years ago
	Or 'Continue Purge?' I don't see why it would need to ask a... In forum Prusa i3 kit (Archive)	8 years ago

Page 2 / 4 Prev Next

Forum Statistics

585 Forums

67.9 K Topics

475.9 K Posts

9 Online

75.5 K Members

Latest Post: Don't fit: Front left and right panel Our newest member: klong Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed