Notifications
Clear all
stahlfabrik
stahlfabrik
Skupina: Registrovaný
Přidal se: 2017/09/11
Honorable Member
1
Exactly! When windows me crashed on me killing all my files...

In forum Hardware, firmware and software help

před 7 years
Where in the firmware can I find the TMC_SET_WAVE_Exxx code...

In forum Hardware, firmware and software help

před 7 years
I did it too! Also 1.05 or 1.06 - again:-) So I now wonder ...

In forum Hardware, firmware and software help

před 7 years
I am curious how that new calibration tower works out for me...

In forum Hardware, firmware and software help

před 7 years
That is where a backup comes in handy.

In forum Hardware, firmware and software help

před 7 years
The stepper drivers measure the amps they send to the motors...

In forum Hardware, firmware and software help

před 7 years
That is easy: with changing the current temperature of the P...

In forum Hardware, firmware and software help

před 7 years
With 3.2.0-RC2 my extruder is noticeably colder than in 3.1....

In forum General discussion, announcements and releases

před 7 years
I must chime in and thank you, stahlfabrik, for your excelle...

In forum Hardware, firmware and software help

před 7 years
Hello! What is the safety way to record my factory assemble...

In forum General discussion, announcements and releases

před 7 years
Oh that is a Good question! How could I find out? And what...

In forum How do I print this? (Printing help)

před 7 years
I must chime in and thank you, stahlfabrik, for your excelle...

In forum Hardware, firmware and software help

před 7 years
Updated my EEPROM and ran tests at 55C and 40C without chang...

In forum Hardware, firmware and software help

před 7 years
Hi Josh, I would suggest to even do a factory reset after t...

In forum Assembly and first prints troubleshooting

před 7 years
Thanks for the clarification, I compiled using latest code f...

In forum Hardware, firmware and software help

před 7 years
How to print Moon City 2.0 nicely?

In forum How do I print this? (Printing help)

před 7 years
The printer does not write to the SD card AFAIK. So you can ...

In forum Hardware, firmware and software help

před 7 years
IMHO Live Z is way to high and try without the tape - you do...

In forum Assembly and first prints troubleshooting

před 7 years
Thanks for this. I finally got some time to do this calibrat...

In forum Hardware, firmware and software help

před 7 years
I think it is the layer seams

In forum General discussion, announcements and releases

před 7 years
Stránka 11 / 35
Share: