ssill2 – Activité – Prusa3D Forum

Notifications

Clear all

ssill2

Groupe: Enregistré

A(ont) rejoint: 2021/01/18

Noble Member

	That seems super annoying to change more than a couple times... Dans le forum How do I print this? (Printing help)	il y a 5 years
	Even though I have beat the MMU into submission and get pret... Dans le forum How do I print this? (Printing help)	il y a 5 years
	on this bvoh + PLA(Ziro Silver Black) Dans le forum How do I print this? (Printing help)	il y a 5 years
	Stuff starts to make sense after you've watched the MMU in o... Dans le forum How do I print this? (Printing help)	il y a 5 years
	Here's what my idler bolt looks like and I print everything ... Dans le forum How do I print this? (Printing help)	il y a 5 years
	The file you have should work, just change filament 5 to be ... Dans le forum How do I print this? (Printing help)	il y a 5 years
	Again this is done with PrusaSlicer 2.4.0 as built from mast... Dans le forum How do I print this? (Printing help)	il y a 5 years
	Still on plate Dans le forum How do I print this? (Printing help)	il y a 5 years
	It’s slightly shorter than the diagonal of the plate. I sli... Dans le forum How do I print this? (Printing help)	il y a 5 years
	I’ve printed 85a with same settings Dans le forum How do I print this? (Printing help)	il y a 5 years
	I find I don’t have to mess with idler bolt. As long as the... Dans le forum How do I print this? (Printing help)	il y a 5 years
	Pva + pla. Dans le forum How do I print this? (Printing help)	il y a 5 years
	rounded(exterior chamfer) end goes down. Dans le forum How do I print this? (Printing help)	il y a 5 years
	I've only used the the ones that came with the assembled hot... Dans le forum How do I print this? (Printing help)	il y a 5 years
	I’m 2mm ID throughout and no issues now oh and here’s latest... Dans le forum How do I print this? (Printing help)	il y a 5 years
	First attempt it great. Running another with improved settin... Dans le forum How do I print this? (Printing help)	il y a 5 years
	I've not had good success with PVA. I was just watching the ... Dans le forum How do I print this? (Printing help)	il y a 5 years
	but it sounds like this is the same issue as Dans le forum How do I print this? (Printing help)	il y a 5 years
	sorry I finally got back to this. I realized that since "ta... Dans le forum How do I print this? (Printing help)	il y a 5 years
	though my feedback has far less weight than those above, I h... Dans le forum How do I print this? (Printing help)	il y a 5 years

Page 56 / 103 Précédent Suivant

Statistiques du forum

598 Forums

70.9 K Sujets

497.3 K Messages

11 En-ligne

82.3 K Membres

Le dernier des messages: Unable to verify Extruder Type Notre nouveau membre: jbpr Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé