Notifications
Clear all
SR22pilot
SR22pilot
Grupa: Zarejestrowany
Dołączył: 2023/01/25
Eminent Member
2
I installed new firmware last night. The humidity informatio...

In forum General discussion, announcements and releases

2 years temu
I thought I would post my experience with X1C speed. I run a...

In forum General discussion, announcements and releases

2 years temu
Glad to do my best. Ask away if you have questions. I promis...

In forum General discussion, announcements and releases

2 years temu
@dimprov There are several solutions out there including Fo...

In forum General discussion, announcements and releases

2 years temu
I’m not a Prusa customer. I found the thread doing a Google ...

In forum General discussion, announcements and releases

2 years temu
I didn’t think you could. Mixing filaments that use the same...

In forum General discussion, announcements and releases

2 years temu
Interesting. When I accidentally picked an ABS spool as a co...

In forum General discussion, announcements and releases

2 years temu
As stated by @Crab, it is much easier to get on the network ...

In forum General discussion, announcements and releases

2 years temu
The video was interesting. The multiple tool-heads offers a ...

In forum General discussion, announcements and releases

2 years temu
Students could slice and save the gcode to a USB stick or pl...

In forum General discussion, announcements and releases

2 years temu
I had to turn off plate recognition. Otherwise, I haven't se...

In forum General discussion, announcements and releases

2 years temu
Not sure about farm support but Bambu Studio certainly seems...

In forum General discussion, announcements and releases

2 years temu
I don't know about Prusamint. I know Protopasta is an issue ...

In forum General discussion, announcements and releases

2 years temu
I have never used a Prusa printer but I do have an X1C and c...

In forum General discussion, announcements and releases

2 years temu
Strona 2 / 2
Share: