Notifications
Clear all
sprocket314
sprocket314
Group: Registered
Joined: 2020/10/27
Eminent Member
2
Thank you so much! This totally makes sense! I will do that ...

In forum Hardware, firmware and software help

1 year ago
This is how my hotend looks like right now. White PLA used l...

In forum Hardware, firmware and software help

1 year ago
Which Hotend does the MK3S use, the 12V or 24V version?

In forum Hardware, firmware and software help

1 year ago
Finally ready to print metal. Does the MK3S have hardened fe...

In forum How do I print this? (Printing help)

3 years ago
@dan-rogers Thank you so much for the level of detail. I jus...

In forum General discussion, announcements and releases

3 years ago
@dan-rogers Clearcoat means that you varnish them? Do you di...

In forum General discussion, announcements and releases

3 years ago
Those sanding sticks look great. I will print them. Which gr...

In forum General discussion, announcements and releases

3 years ago
How to best sand prints (e.g. when removing supports)?

In forum General discussion, announcements and releases

3 years ago
Thank you so far for the suggestions! I print as a hobby, so...

In forum General discussion, announcements and releases

3 years ago
Which air purifier to use (if any)?

In forum General discussion, announcements and releases

3 years ago
More points to Octoprint... SD card works well, but having ...

In forum General discussion, announcements and releases

3 years ago
I'm definitely intrigued by Octoprint. However, I pretty muc...

In forum General discussion, announcements and releases

3 years ago
What happens if I remove the SD card halfway through a print...

In forum General discussion, announcements and releases

3 years ago
Many thanks for both helpful answers!

In forum How do I print this? (Printing help)

3 years ago
What's the real maximum printing volume?

In forum How do I print this? (Printing help)

3 years ago
@charles-h13 Good idea. My only concern is that I won't easi...

In forum General discussion, announcements and releases

3 years ago
Just ordered one! It will arrive tomorrow.

In forum General discussion, announcements and releases

3 years ago
@baklin The PLA spatula idea sounds really good to me. The o...

In forum General discussion, announcements and releases

3 years ago
Should we use a cover for the printer to avoid dust when not...

In forum General discussion, announcements and releases

3 years ago
@jsw 🤣 I was familiar with RTFM as I work in IT, but did not...

In forum General discussion, announcements and releases

3 years ago
Page 1 / 2
Share: