Spradlinb – Activité – Prusa3D Forum

Notifications

Clear all

Spradlinb

Groupe: Enregistré

A(ont) rejoint: 2016/12/20

Eminent Member

	Quick question, but how do I reset the presets in Slic3r to ... Dans le forum Hardware, firmware and software help	il y a 7 years
	Where is the chat? I can't find anywhere to talk with them d... Dans le forum Others (Archive)	il y a 8 years
	I was curious about this one myself, as my previous printer ... Dans le forum Print tips (Archive)	il y a 8 years
	@JeffJordan Was that in response to my question or another ... Dans le forum Others (Archive)	il y a 9 years
	Excellent! I was just getting ready to upgrade the firmware ... Dans le forum Others (Archive)	il y a 9 years
	I printed with PETG and the sizes matched perfectly with the... Dans le forum Others (Archive)	il y a 9 years
	So has there been any consensus on PETG vs ABS for the repla... Dans le forum Others (Archive)	il y a 9 years
	Kit build y-motor mount broken Dans le forum Others (Archive)	il y a 9 years
	Mine arrived today, in the middle of Nebraska. The shipment ... Dans le forum General discussion, announcements and releases	il y a 9 years

Page 2 / 2 Précédent

Statistiques du forum

585 Forums

68.2 K Sujets

477.7 K Messages

11 En-ligne

75.9 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé