Prusa3D Forum

Notifications

Clear all

sppeart

Skupina: Registrovaný

Přidal se: 2022/05/05

Active Member

	After loosening my idler tension, removing the insulation in... In forum General discussion, announcements and releases	před 3 years
	The enclosure isn’t sealed, but I did line the inside with p... In forum General discussion, announcements and releases	před 4 years
	Firstly – thank you all for the tips and suggestions. As far... In forum General discussion, announcements and releases	před 4 years
	The nozzle is unscrewed. I was holding the whole thing in pl... In forum General discussion, announcements and releases	před 4 years
	Extruder still constantly plugging/clicking - what else can ... In forum General discussion, announcements and releases	před 4 years

Fórum Statistiky

595 Fóra

68.8 K Témata

481.5 K Příspěvky

14 Online

77.4 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed