spiff72 – Aktivita – Prusa3D Forum

Notifications

Clear all

spiff72

Skupina: Registrovaný

Přidal se: 2019/07/15

Trusted Member

	I think I got rid of the snagging by tightening up the wrap.... In forum Assembly and first prints troubleshooting	před 5 years
	The bundle covers are 100% stock - this is what came with my... In forum Assembly and first prints troubleshooting	před 5 years
	The print bed has an alternate 45 degree cover for the conne... In forum Assembly and first prints troubleshooting	před 5 years
	@robert-rmm200 I will check that too... Pretty sure that it ... In forum Assembly and first prints troubleshooting	před 5 years
	(I also slowed my travel speed down from 180 mm/s to 100 mm/... In forum Assembly and first prints troubleshooting	před 5 years
	This is all good info... To add to the issues - the part pic... In forum Assembly and first prints troubleshooting	před 5 years
	Note: I was using the 0.20 mm Quality PETG profile. Anoth... In forum Assembly and first prints troubleshooting	před 5 years
	Ugh - Layer shift near print finish In forum Assembly and first prints troubleshooting	před 5 years
	I will give the sheet a good cleaning. All the prints I have... In forum Assembly and first prints troubleshooting	před 5 years
	Update: Implementing the settings suggested by guy-k2 helped... In forum Assembly and first prints troubleshooting	před 5 years
	I might give that a try too - I just sliced with the bottom ... In forum Assembly and first prints troubleshooting	před 5 years
	Thanks for the suggestions! The print I ran overnight with t... In forum Assembly and first prints troubleshooting	před 5 years
	Yes, the fillet you show there is from one of the two short ... In forum Assembly and first prints troubleshooting	před 5 years
	Thanks for the reply. The surface showing the issue is a cha... In forum Assembly and first prints troubleshooting	před 5 years
	Here is a link to an imgur gallery with bigger photos: In forum Assembly and first prints troubleshooting	před 5 years
	Looking for suggestions - overhangs not looking good In forum Assembly and first prints troubleshooting	před 5 years
	Thanks Bob, That was an interesting read. ("It's all an illu... In forum Assembly and first prints troubleshooting	před 5 years
	Well - that re-slicing with the slower settings may have sol... In forum Assembly and first prints troubleshooting	před 5 years
	Extruder(?) clicking during print? In forum Assembly and first prints troubleshooting	před 5 years
	So based on this bit of the code from the ABS gcode below(I ... In forum Assembly and first prints troubleshooting	před 5 years

Stránka 4 / 5 Předchozí Další

Fórum Statistiky

559 Fóra

62.9 K Témata

442.9 K Příspěvky

22 Online

67.6 K Uživatelé

Poslední Příspěvek: Rounded corners printed upside down Nový Uživatel: pinklemonade Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed