spiff72 – Aktivität – Prusa3D Forum

Benachrichtigungen

Alles löschen

spiff72

Gruppe: Registriert

Beigetreten: 2019/07/15

Trusted Member

	I think I got rid of the snagging by tightening up the wrap.... Im Forum Assembly and first prints troubleshooting	Vor 5 years
	The bundle covers are 100% stock - this is what came with my... Im Forum Assembly and first prints troubleshooting	Vor 5 years
	The print bed has an alternate 45 degree cover for the conne... Im Forum Assembly and first prints troubleshooting	Vor 5 years
	@robert-rmm200 I will check that too... Pretty sure that it ... Im Forum Assembly and first prints troubleshooting	Vor 5 years
	(I also slowed my travel speed down from 180 mm/s to 100 mm/... Im Forum Assembly and first prints troubleshooting	Vor 5 years
	This is all good info... To add to the issues - the part pic... Im Forum Assembly and first prints troubleshooting	Vor 5 years
	Note: I was using the 0.20 mm Quality PETG profile. Anoth... Im Forum Assembly and first prints troubleshooting	Vor 5 years
	Ugh - Layer shift near print finish Im Forum Assembly and first prints troubleshooting	Vor 5 years
	I will give the sheet a good cleaning. All the prints I have... Im Forum Assembly and first prints troubleshooting	Vor 5 years
	Update: Implementing the settings suggested by guy-k2 helped... Im Forum Assembly and first prints troubleshooting	Vor 5 years
	I might give that a try too - I just sliced with the bottom ... Im Forum Assembly and first prints troubleshooting	Vor 5 years
	Thanks for the suggestions! The print I ran overnight with t... Im Forum Assembly and first prints troubleshooting	Vor 5 years
	Yes, the fillet you show there is from one of the two short ... Im Forum Assembly and first prints troubleshooting	Vor 5 years
	Thanks for the reply. The surface showing the issue is a cha... Im Forum Assembly and first prints troubleshooting	Vor 5 years
	Here is a link to an imgur gallery with bigger photos: Im Forum Assembly and first prints troubleshooting	Vor 5 years
	Looking for suggestions - overhangs not looking good Im Forum Assembly and first prints troubleshooting	Vor 5 years
	Thanks Bob, That was an interesting read. ("It's all an illu... Im Forum Assembly and first prints troubleshooting	Vor 5 years
	Well - that re-slicing with the slower settings may have sol... Im Forum Assembly and first prints troubleshooting	Vor 5 years
	Extruder(?) clicking during print? Im Forum Assembly and first prints troubleshooting	Vor 5 years
	So based on this bit of the code from the ABS gcode below(I ... Im Forum Assembly and first prints troubleshooting	Vor 5 years

Seite 4 / 5 Vorherige Nächstes

Forums-Statistiken

559 Foren

62.9 K Themen

442.9 K Beiträge

21 Online

67.6 K Mitglieder

Letzter Beitrag: how to wired ? Unser neuestes Mitglied: pinklemonade Neueste Beiträge Ungelesene Beiträge Schlagwörter

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen