Notifications
Clear all
Spankyty
Skupina: Registrovaný
Přidal se: 2017/02/08
Active Member
1
| I am using Inland PLA+ without any changes to the advanced t... | před 4 years | |
|
There are more experienced people here than me, but I think ... In forum Others (Archive) |
před 8 years | |
|
So it is hard to diagnose without seeing it. I will just bl... In forum Others (Archive) |
před 8 years | |
|
You need to calibrate your Z offset. Basically, the printe... In forum Others (Archive) |
před 8 years | |
|
Filament gets stuck on nozzle. Not clogged. In forum Others (Archive) |
před 8 years |