Notifications
Clear all
sorslyd5
Grupa: Zarejestrowany
Dołączył: 2017/11/05
Active Member
1
| First layer adhesion (water fix??) | 7 years temu | |
| Could it be confused about its position? I would suggest ... | 7 years temu | |
| The filament I was working with may have gotten stuck in the... | 7 years temu | |
| Could it be confused about its position? I would suggest ... | 7 years temu | |
| So I tried the same print again, managed to get further than... | 7 years temu | |
| Tension spring replacement | 7 years temu | |
|
Broke out my calipers and did a quick measure: 2.3mm In forum Hardware, firmware and software help |
7 years temu | |
| So I've managed to clear the jam with your advice, but becau... | 7 years temu | |
| You have filament jammed between selector and idler. Please... | 7 years temu | |
| Don't think the pulley is worn, just full up with filament. ... | 7 years temu | |
| I'm just starting as well, but I spent a bunch of hours yest... | 7 years temu | |
| No longer capable of retraction | 7 years temu | |
|
I pre-ordered the MK3, and it'll be my first 3d printer...
... In forum Others (Archive) |
8 years temu |