Prusa3D Forum

Notifications

Clear all

SometimesSteve

Groupe: Enregistré

A(ont) rejoint: 2016/08/27

Active Member

	So S3D does fine, but Prusa's software makes a tangled mess ... Dans le forum Others (Archive)	il y a 8 years
	Printed fine how? In a normal slice? With which slicer? With... Dans le forum Others (Archive)	il y a 8 years
	So it definitely appears to be a Prusa Slic3r issue then. Is... Dans le forum Others (Archive)	il y a 8 years
	Attached is a zip of the stl, a sprial vase sliced version, ... Dans le forum Others (Archive)	il y a 8 years
	I can post all of my generated files for that model in 5-6 h... Dans le forum Others (Archive)	il y a 8 years
	It is not a pretty model, but it proved a good enough test p... Dans le forum Others (Archive)	il y a 8 years
	Lol, no no that's martin's GCode. Mines at home but him and ... Dans le forum Others (Archive)	il y a 8 years
	Hey that's not me! Although I'll bet my gcode is similar, wh... Dans le forum Others (Archive)	il y a 8 years
	Any other thoughts as to what is going wrong? Dans le forum Others (Archive)	il y a 8 years
	Did you get your candy? Mine came with candy, perhaps the my... Dans le forum Others (Archive)	il y a 8 years
	Are you using Slic3r? I have the same problem with vase mode... Dans le forum Others (Archive)	il y a 8 years
	Spiral Vase problem Dans le forum Others (Archive)	il y a 8 years

Statistiques du forum

566 Forums

63.1 K Sujets

444 K Messages

24 En-ligne

68.1 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé