Notifications
Clear all
sleepysnorlax
Group: Registered
Joined: 2021/03/20
Active Member
1
|
Thanks for the comment about the PINDA being less accurate f... In forum Hardware, firmware and software help |
1 month ago | |
|
Difficulty with Bed Leveling In forum Hardware, firmware and software help |
2 months ago | |
| Here is the 75mm x 75mm print from above post. It was quite ... | 4 years ago | |
| First off, I appreciate the thorough response. I haven't use... | 4 years ago | |
| Corners Lifting During Prints | 4 years ago |