Prusa3D Forum

Notifications

Clear all

SkynetCH

Groupe: Enregistré

A(ont) rejoint: 2017/02/03

Active Member

	which firmware shall I choose for a MK2S, or what's the diff... Dans le forum Others (Archive)	il y a 8 years
	yes you can, if the USB cam is linux compatible, I use the r... Dans le forum Improvements (Archive)	il y a 8 years
	you could also give Astroprint a try, it's very similiar to... Dans le forum Improvements (Archive)	il y a 8 years
	I really think the bearing was faulty, my other hobby is rc ... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Its the X not Y axis, the bed is smooth, with the belt remov... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	[MK2S] X axis smoothrod deep scar / scratch Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	➡ with an uncalibrated kit/printer, this is quite nor... Dans le forum Others (Archive)	il y a 8 years
	I just built my MK2s a few days ago. I'm using a 40mm noctu... Dans le forum Others (Archive)	il y a 8 years
	Placed my order for a prusa kit (orange/black) on 03.02.2017... Dans le forum General discussion, announcements and releases	il y a 8 years

Statistiques du forum

565 Forums

64.5 K Sujets

451.8 K Messages

23 En-ligne

71.1 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé