Benachrichtigungen
Alles löschen
skipZero
skipZero
Gruppe: Registriert
Beigetreten: 2017/06/29
Active Member
1
Cool. I'll look deeper into it if needed. All the ones very ...

Im Forum General discussion, announcements and releases

Vor 4 months
Hi Matt. Cool. I'll send ya a message and see if it'll worko...

Im Forum General discussion, announcements and releases

Vor 4 months
one would think, right? It's not so handy. I'm even on there...

Im Forum General discussion, announcements and releases

Vor 4 months
Local Prusa XL?

Im Forum General discussion, announcements and releases

Vor 4 months
Considering the z index isn't part of the build plate, I'd c...

Im Forum General discussion, announcements and releases

Vor 5 years
Continued "some problem encountered, Z leveling enforced"...

Im Forum Hardware, firmware and software help

Vor 5 years
Turned out the wires from the MMU board weren't actually con...

Im Forum Hardware, firmware and software help

Vor 5 years
MMU2S won't turn on after upgrading

Im Forum Hardware, firmware and software help

Vor 5 years
I haven't checked under the board, but it doesn't seem to be...

Im Forum Hardware, firmware and software help

Vor 6 years
yup, I did and no, or at times very little, power from the b...

Im Forum Hardware, firmware and software help

Vor 6 years
I'm gonna take it that no one has anything to add and that t...

Im Forum Hardware, firmware and software help

Vor 6 years
Yes. Several times as I tested other things.

Im Forum Hardware, firmware and software help

Vor 6 years
Heat Bed pre heat error - time for a new board?

Im Forum Hardware, firmware and software help

Vor 6 years
It seams the plug on the ribbon probably wasn't seated right...

Im Forum Hardware, firmware and software help

Vor 6 years
w00t!! So for the heck of it, I turned off the printer, remo...

Im Forum Hardware, firmware and software help

Vor 6 years
failed flashing. I can't take a look at the log, though, for...

Im Forum Hardware, firmware and software help

Vor 6 years
I haven't tried reflashing. If it's not showing up for octop...

Im Forum Hardware, firmware and software help

Vor 6 years
Since I only unplugged one of the ribbons from the LCD, I'm ...

Im Forum Hardware, firmware and software help

Vor 6 years
Ooops... Might have fried my Rambo electronics

Im Forum Hardware, firmware and software help

Vor 6 years
Teilen: