Prusa3D Forum

Notifications

Clear all

skinnyb

Groupe: Enregistré

A(ont) rejoint: 2023/08/29

Active Member

	I disassembled my gears down to the one that grips the filam... Dans le forum Hardware, firmware and software help	il y a 3 weeks
	I also reran all the tests on it and it passed it all... Dans le forum Hardware, firmware and software help	il y a 3 weeks
	My filament load motor bad? Dans le forum Hardware, firmware and software help	il y a 3 weeks
	Enclosure after upgrade? Dans le forum Assembly and first prints troubleshooting	il y a 9 months
	If I wanted to print other types of filaments though, would ... Dans le forum General discussion, announcements and releases	il y a 2 years
	Ventilation question Dans le forum General discussion, announcements and releases	il y a 2 years
	Thanks, I talked to support last night and am awaiting infor... Dans le forum Assembly and first prints troubleshooting	il y a 2 years
	Yeah that's what it "should" do, but mine seems to stop part... Dans le forum Assembly and first prints troubleshooting	il y a 2 years
	Hot end assembly question Dans le forum Assembly and first prints troubleshooting	il y a 2 years

Statistiques du forum

595 Forums

69.6 K Sujets

487.5 K Messages

12 En-ligne

79.7 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé