Prusa3D Forum

Notifications

Clear all

skatun

Skupina: Registrovaný

Přidal se: 2022/10/07

Active Member

	So I can finally confirm that it prints nicely again with bo... In forum Hardware, firmware and software help	před 2 years
	RE: Filament only prints for a limited time In forum Hardware, firmware and software help	před 2 years
	its at 0.8 now, and 0.4mm z movement, Is there a G-code samp... In forum Hardware, firmware and software help	před 2 years
	RE: Filament only prints for a limited time In forum Hardware, firmware and software help	před 2 years
	So I have printed for roughly 14 hours since last update, an... In forum Hardware, firmware and software help	před 2 years
	Quick night update, So I found a few errors, the PTFE tube w... In forum Hardware, firmware and software help	před 2 years
	here is a picture Today its stopped printing after 1hour, ... In forum Hardware, firmware and software help	před 2 years
	Thanks for the reply, I noticed one thing, that the idler sp... In forum Hardware, firmware and software help	před 2 years
	Filament only prints for a limited time In forum Hardware, firmware and software help	před 2 years

Fórum Statistiky

566 Fóra

63.1 K Témata

444.1 K Příspěvky

21 Online

68.1 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed