Prusa3D Forum

Notifications

Clear all

skatun

Group: Registered

Joined: 2022/10/07

Active Member

	So I can finally confirm that it prints nicely again with bo... In forum Hardware, firmware and software help	2 years ago
	RE: Filament only prints for a limited time In forum Hardware, firmware and software help	2 years ago
	its at 0.8 now, and 0.4mm z movement, Is there a G-code samp... In forum Hardware, firmware and software help	2 years ago
	RE: Filament only prints for a limited time In forum Hardware, firmware and software help	2 years ago
	So I have printed for roughly 14 hours since last update, an... In forum Hardware, firmware and software help	2 years ago
	Quick night update, So I found a few errors, the PTFE tube w... In forum Hardware, firmware and software help	2 years ago
	here is a picture Today its stopped printing after 1hour, ... In forum Hardware, firmware and software help	2 years ago
	Thanks for the reply, I noticed one thing, that the idler sp... In forum Hardware, firmware and software help	2 years ago
	Filament only prints for a limited time In forum Hardware, firmware and software help	2 years ago

Forum Statistics

566 Forums

63.1 K Topics

444.1 K Posts

20 Online

68 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed