Notifications
Clear all
Sigurður Ásgeirsson
Sigurður Ásgeirsson
Grupa: Zarejestrowany
Dołączył: 2023/05/18
Eminent Member
2
Yeah, I hear you. Makes sense. I just need to gird my loins....

In forum Hardware, firmware and software help

1 year temu
I should mention I've set up OctoPrint serial logging just n...

In forum Hardware, firmware and software help

1 year temu
Mkay, I adjusted the filament sensor to where it thinks it's...

In forum Hardware, firmware and software help

1 year temu
And here on printables.

In forum Hardware, firmware and software help

1 year temu
Ah, thanks - found it here, or at least something very like ...

In forum Hardware, firmware and software help

1 year temu
Recognize this filament sensor upgrade?

In forum Hardware, firmware and software help

1 year temu
Thanks - I picked up some silicone heat transfer compound fr...

In forum Hardware, firmware and software help

1 year temu
I broke the heat break loose of the heater block, and it too...

In forum Hardware, firmware and software help

2 years temu
E3D V6 hotend maintenance advice

In forum Hardware, firmware and software help

2 years temu
Good call - I took a closer look at the screws and they're n...

In forum Hardware, firmware and software help

2 years temu
So, I think this printer may have originally had leadscrews,...

In forum Hardware, firmware and software help

2 years temu
So the X-axis parts look very much like the Bear labs X-axis...

In forum Hardware, firmware and software help

2 years temu
I think this is why I'm having trouble with XYZ axis calibra...

In forum Hardware, firmware and software help

2 years temu
It looks like my problem is at the right end of the X-axis, ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years temu
I'm now struggling with the calibration of the thing. Initia...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years temu
Thanks - I acquired a second hand MK3S with the MMU, BondTec...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years temu
Because of the 0.9 degree steppers, I built my own custom fi...

In forum Hardware, firmware and software help

2 years temu
Weirdness - there was apparently something in the metadata o...

In forum Hardware, firmware and software help

2 years temu
Here are some pics of the extruder and the hotend: I...

In forum Hardware, firmware and software help

2 years temu
Hmmm, I see my previous message is "Awaiting moderation". Ma...

In forum Hardware, firmware and software help

2 years temu
Strona 1 / 2
Share: