|
I for one have had enough of this, i will take no further pa... In forum General discussion, announcements and releases |
3 years ago |
|
not got fully to grips with it yet, put a few on to see what... In forum General discussion, announcements and releases |
3 years ago |
|
As i said above the print is used to prove the design, It is... In forum General discussion, announcements and releases |
3 years ago |
|
Hi, agree up to a point, but all my designs and prints have ... In forum General discussion, announcements and releases |
3 years ago |
|
I seem to have got the hang of loading posts/makes, but sti... In forum General discussion, announcements and releases |
3 years ago |
|
many thanks will try that In forum General discussion, announcements and releases |
3 years ago |
|
hi, question 1 how do i change draft into published ... In forum General discussion, announcements and releases |
3 years ago |
|
As said just hobby now, not after any reward, recognition or... In forum General discussion, announcements and releases |
3 years ago |
|
Hi, till retirement was a cad/cam lecturer, many of my thing... In forum General discussion, announcements and releases |
3 years ago |
|
I thanks for info, had a go at loading a design yesterday, t... In forum General discussion, announcements and releases |
3 years ago |
|
READ everything,loads of publicity, but no actual info/instr... In forum General discussion, announcements and releases |
3 years ago |
|
just read this and tested mine, the extruder motor is too ho... In forum Others (Archive) |
7 years ago |
|
no reply to this problem, or to emails to support,regarding ... In forum Others (Archive) |
7 years ago |
|
I too have problems with 1st layer adhesion, the test strip ... In forum Others (Archive) |
7 years ago |
