Prusa3D Forum

Notifications

Clear all

shinwachi

Group: Registered

Joined: 2020/01/01

Active Member

	Just an update - I've temporarily solved the fan issue by dr... In forum Hardware, firmware and software help	5 years ago
	I just measured it - it is almost exactly 4.8 mm gap. So ad... In forum Hardware, firmware and software help	5 years ago
	@joantabb Yes, it's the new Mini. In forum Hardware, firmware and software help	5 years ago
	@bobstro It's not scalding hot, but uncomfortably warm. I w... In forum Hardware, firmware and software help	5 years ago
	@joantabb Hi Joan. The brass connector is the one from top ... In forum Hardware, firmware and software help	5 years ago
	@lichtjaeger I'm having issue post heat break modification n... In forum Assembly and first prints troubleshooting	5 years ago
	Looks like jams are back again 🙁 This time on top of heat ... In forum Hardware, firmware and software help	5 years ago
	Yes, the loose assembly of the heatbreak and hot end was the... In forum Hardware, firmware and software help	5 years ago
	Jams in heatbreak 🙁 Any way to boost voltage to fans? In forum Hardware, firmware and software help	5 years ago

Forum Statistics

559 Forums

63 K Topics

443.6 K Posts

22 Online

68 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed