Notifications
Clear all
Shelby Teknologies
Shelby Teknologies
Group: Registered
Joined: 2018/08/18
Active Member
1
Definitely not that. This was after the 2nd spool was used. ...

In forum Assembly and first prints troubleshooting

6 months ago
Very odd as you can see it starts out great then after about...

In forum Assembly and first prints troubleshooting

10 months ago
RE: print fading as it goes up and to the right

In forum Assembly and first prints troubleshooting

10 months ago
print fading as it goes up and to the right

In forum Assembly and first prints troubleshooting

10 months ago
print fading as it goes up and to the right

In forum Assembly and first prints troubleshooting

10 months ago
3.81/1.06 firmware seems to have issues

In forum Hardware, firmware and software help

6 years ago
I sent a message to support and they were most helpful. All ...

In forum Assembly and first prints troubleshooting

6 years ago
Problem #2 has been fixed after reattaching the cable to the...

In forum Assembly and first prints troubleshooting

6 years ago
Selftest print fan failure

In forum Assembly and first prints troubleshooting

6 years ago
I just received my notification the MMU is on the way!!!!!

In forum General discussion, announcements and releases

6 years ago
A lot of good points and constructive comments. Thank you f...

In forum General discussion, announcements and releases

6 years ago
Filament buildup detection

In forum General discussion, announcements and releases

6 years ago
That may be the case but I'm paying interest on the charges ...

In forum General discussion, announcements and releases

6 years ago
MMU2s delays

In forum General discussion, announcements and releases

6 years ago
I just used guy.k2's profiles for the Amazon PETG and right ...

In forum How do I print this? (Printing help)

7 years ago
It was better but still failed. Is anyone else changing thi...

In forum Assembly and first prints troubleshooting

7 years ago
I noticed the first layer was being done at 230C and other l...

In forum Assembly and first prints troubleshooting

7 years ago
Some prints work, some don't

In forum Assembly and first prints troubleshooting

7 years ago
Share: