Notifications
Clear all
Sharif
Skupina: Registrovaný
Přidal se: 2019/07/21
Active Member
1
|
Slic3r UI modification In forum PrusaSlicer |
před 5 years | |
|
The original picture was when I printed 1/2 of wheel hub. I... In forum Hardware, firmware and software help |
před 5 years | |
|
Finished Part.... In forum Hardware, firmware and software help |
před 5 years | |
|
I was using a textured surface. My bed is clean and everyth... In forum Hardware, firmware and software help |
před 5 years | |
|
Thanks In forum Hardware, firmware and software help |
před 5 years | |
|
I think @connorbadenko is referring to supports not sticking... In forum Hardware, firmware and software help |
před 5 years | |
|
I have the same problem. I ended up adding a thin object to... In forum Print tips (Archive) |
před 5 years |