Notifications
Clear all
Sharif
Groupe: Enregistré
A(ont) rejoint: 2019/07/21
Active Member
1
|
Slic3r UI modification Dans le forum PrusaSlicer |
il y a 6 years | |
|
The original picture was when I printed 1/2 of wheel hub. I... Dans le forum Hardware, firmware and software help |
il y a 6 years | |
|
Finished Part.... Dans le forum Hardware, firmware and software help |
il y a 6 years | |
|
I was using a textured surface. My bed is clean and everyth... Dans le forum Hardware, firmware and software help |
il y a 6 years | |
|
Thanks Dans le forum Hardware, firmware and software help |
il y a 6 years | |
|
I think @connorbadenko is referring to supports not sticking... Dans le forum Hardware, firmware and software help |
il y a 6 years | |
|
I have the same problem. I ended up adding a thin object to... Dans le forum Print tips (Archive) |
il y a 6 years |