Notifications
Clear all
ShaneG
Skupina: Registrovaný
Přidal se: 2025/03/11
Active Member
1
| 35C ish with PLA and around 40C for PETG, it's about borderl... | před 10 months | |
| Yes | před 10 months | |
| I printed some ASA and PC blend yesterday. I'm too paranoid ... | před 10 months | |
| With volatiles yeah, then it runs to vent after the print.Bu... | před 10 months | |
| Yeah I'm mostly just disappointed as to the lack of explanat... | před 10 months | |
| Nope, just the blower from the filtration unit. You can run ... | před 10 months | |
| It doesn't make too much noise, much less than the case fans... | před 10 months | |
| Just installed mine | před 10 months | |
|
The camera is powered by the printer, so if I power off the ... In forum Buddy3D |
před 11 months | |
|
Core One Buddy Camera Forgets Network Data In forum Buddy3D |
před 11 months | |
| I got a satin sheet and I'm very happy with it | před 11 months | |
| Arrived today (DHL) and happily chugging away. | před 11 months | |
| Batch 11 (Assembled) and just got a "shipped" notification.A... | před 11 months |