Notifications
Clear all
ShaneG
Group: Registered
Joined: 2025/03/11
Active Member
1
| 35C ish with PLA and around 40C for PETG, it's about borderl... | 6 months ago | |
| Yes | 6 months ago | |
| I printed some ASA and PC blend yesterday. I'm too paranoid ... | 6 months ago | |
| With volatiles yeah, then it runs to vent after the print.Bu... | 6 months ago | |
| Yeah I'm mostly just disappointed as to the lack of explanat... | 6 months ago | |
| Nope, just the blower from the filtration unit. You can run ... | 6 months ago | |
| It doesn't make too much noise, much less than the case fans... | 6 months ago | |
| Just installed mine | 6 months ago | |
|
The camera is powered by the printer, so if I power off the ... In forum Buddy3D |
7 months ago | |
|
Core One Buddy Camera Forgets Network Data In forum Buddy3D |
7 months ago | |
| I got a satin sheet and I'm very happy with it | 7 months ago | |
| Arrived today (DHL) and happily chugging away. | 7 months ago | |
| Batch 11 (Assembled) and just got a "shipped" notification.A... | 7 months ago |