Prusa3D Forum

Notifications

Clear all

Seth

Groupe: Enregistré

A(ont) rejoint: 2016/08/28

Active Member

	Hi, Sharron, I've been having clogging issues too and notice... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	I got the replacement LCD. I plugged it in and it's working... Dans le forum Others (Archive)	il y a 8 years
	If your probe is set correctly, maybe your heatbed has warpe... Dans le forum Others (Archive)	il y a 8 years
	Hi, Manuel. I recently noticed my Y-carriage was freely rot... Dans le forum Hardware, firmware and software help	il y a 8 years
	Nozzle drags across model at end of print Dans le forum Print tips (Archive)	il y a 8 years
	Hey, In the prusa folder you downloaded for Mac from the dri... Dans le forum Software (Archive)	il y a 8 years
	Update: After some more troubleshooting, the techs have dec... Dans le forum Others (Archive)	il y a 8 years
	Well, I pried those tabs out of the connectors on one cable.... Dans le forum Others (Archive)	il y a 8 years
	There are a couple of things you can do: Re-route the cable... Dans le forum Others (Archive)	il y a 8 years
	As you describe the fault got worse over time and no chance ... Dans le forum Others (Archive)	il y a 8 years
	Here are a few pics. Dans le forum Others (Archive)	il y a 8 years
	LCD screen jumbled/scrambled Dans le forum Others (Archive)	il y a 8 years

Statistiques du forum

559 Forums

62.9 K Sujets

443 K Messages

20 En-ligne

67.7 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé