Notifications
Clear all
Scon
Skupina: Registrovaný
Přidal se: 2017/12/15
Active Member
1
| You can alter the Gcode of the printer so the gantry will mo... | před 5 months | |
| Just came off chat with Prusa about my assembled Core One or... | před 5 months | |
| You can check in your printer settings under advanced "use f... | před 6 months | |
|
Thanks for your reply. Already cleaned the bed with 99,9 IPA... In forum Others (Archive) |
před 8 years | |
|
Straight 3D print curves on table? In forum Others (Archive) |
před 8 years |