Prusa3D Forum

Notifications

Clear all

Sandro

Skupina: Registrovaný

Přidal se: 2021/08/06

Active Member

	Hey Peepz! I was totally lost in an other project. So hap... In forum How do I print this? (Printing help)	před 4 years
	Ok, SwissCheese. I'll try these Z-Settings. Already getting ... In forum How do I print this? (Printing help)	před 4 years
	Ok, Fuchsr. Here we go. As u said, first layer bad. Yep. ... In forum How do I print this? (Printing help)	před 4 years
	Hello Fuchsr! Thx for ur advice!During my research I found t... In forum How do I print this? (Printing help)	před 4 years
	if it is not the alcohol, then I probably had too less alcoh... In forum How do I print this? (Printing help)	před 4 years
	hi ssill2! After 5 little print jobs it happend again... I s... In forum How do I print this? (Printing help)	před 4 years
	Thanks for your fast response! I tried to keep it clean with... In forum How do I print this? (Printing help)	před 4 years
	RE: Pics In forum How do I print this? (Printing help)	před 4 years
	Oozing after traveling and retraction, and sudden first laye... In forum How do I print this? (Printing help)	před 4 years

Fórum Statistiky

595 Fóra

69.4 K Témata

486 K Příspěvky

14 Online

79.2 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed