ryan.f15 – Activité – Prusa3D Forum

Notifications

Clear all

ryan.f15

Groupe: Enregistré

A(ont) rejoint: 2017/10/25

Estimable Member

	Right side X carriage sags Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	Ok well I've been at this all day. Probe worked, then sudde... Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	Not as far as I can tell. I have everything configured exac... Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	Second bad PINDA? How fragile are these? Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	No, it is like halfway through a layer. Dans le forum Print tips (Archive)	il y a 7 years
	Random layer separation Dans le forum Print tips (Archive)	il y a 7 years
	Oh, and I did lower the sensor very, very slightly and I am ... Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	The problem is that it will do a few good prints then sudden... Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	Well got another pinda and bed. Prints look MUCH better but... Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	Bed leveling failed after three prints Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	I understand that, but that doesn't explain the "Bed Levelin... Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	No everything is assembled as required in the instructions. ... Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	Is my bed warped? Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	I did that. I've been back and forth with tech support. La... Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	Can't get good print Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	Repair broken bearing Dans le forum Others (Archive)	il y a 7 years
	I keep trying to print that and it will print twice, then gi... Dans le forum Others (Archive)	il y a 7 years
	I clean with 50% alcohol after almost every print. Dans le forum Others (Archive)	il y a 7 years
	Okay. So I tried using the original prusa filament. I manage... Dans le forum Others (Archive)	il y a 7 years
	No, in this case I'm using pla for everything. Dans le forum Others (Archive)	il y a 7 years

Page 6 / 7 Précédent Suivant

Statistiques du forum

566 Forums

63.1 K Sujets

444.1 K Messages

24 En-ligne

68.1 K Membres

Le dernier des messages: What does this chamber temperature setting do at a MK3s+? Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé