Activité
 
Notifications
Clear all
Rusty
Rusty
Groupe: Enregistré
A(ont) rejoint: 2019/06/03
Trusted Member
3
Watching this thread. Waiting for my MK4. When I had troubl...

Dans le forum How do I print this? (Printing help)

il y a 1 year
Will accessories made for MK3s fit on the MK4

Dans le forum General discussion, announcements and releases

il y a 1 year
@cameron-reuter, I too have had problems printing PLA+ on th...

Dans le forum General discussion, announcements and releases

il y a 5 years
Thanks. You all have been great helping me sort out the fine...

Dans le forum General discussion, announcements and releases

il y a 5 years
Thanks @robert-rmm200, I think I understand now. After looki...

Dans le forum General discussion, announcements and releases

il y a 5 years
Thanks All, @robert-rmm200, setting the PETG temp is not sho...

Dans le forum General discussion, announcements and releases

il y a 5 years
Thanks @charles-h13, I checked out & followed the link y...

Dans le forum General discussion, announcements and releases

il y a 5 years
Need help Please with how to setup the new Textured Plate

Dans le forum General discussion, announcements and releases

il y a 5 years
@rmm200, good point, I am test printing with PLA+ and I will...

Dans le forum General discussion, announcements and releases

il y a 5 years
Thanks @bobstro, great tip/advice, you nailed it. I checked...

Dans le forum General discussion, announcements and releases

il y a 5 years
RE: Issue with PLA print but works when using PETG settings

Dans le forum General discussion, announcements and releases

il y a 5 years
Issue with PLA print but works when using PETG settings

Dans le forum General discussion, announcements and releases

il y a 5 years
Thanks @peter-m26, I like your "Z" tip about holding down th...

Dans le forum General discussion, announcements and releases

il y a 5 years
Thanks @jbinfl, I will keep an eye out for too much extruder...

Dans le forum General discussion, announcements and releases

il y a 5 years
Thanks to all that contributed to this conversation. Good ar...

Dans le forum General discussion, announcements and releases

il y a 5 years
Thanks @david-a66, @tim-m30. Good explanation Tim. What sh...

Dans le forum General discussion, announcements and releases

il y a 5 years
Extruder Settings help please

Dans le forum General discussion, announcements and releases

il y a 5 years
Thanks @bobstro, too old to start learning code, learning Fu...

Dans le forum General discussion, announcements and releases

il y a 5 years
What is the correct procedure to shutdown the extruder?

Dans le forum General discussion, announcements and releases

il y a 5 years
Thanks @neophyl, @gnat, @tim-m30, for the clarifications, ad...

Dans le forum General discussion, announcements and releases

il y a 5 years
Page 2 / 4
Partager :