Notifications
Clear all
Rui Guerra
Rui Guerra
Group: Registered
Joined: 2025/01/21
Active Member
1
It looks like no one else has a clear answer to this (?)

In forum User mods, enclosures, nozzles, ...

1 week ago
So that means no more nozzle size restrictions with MMU3? Is...

In forum User mods, enclosures, nozzles, ...

5 months ago
0.25 nozzle with MMU3 + MK4?

In forum User mods, enclosures, nozzles, ...

6 months ago
Thanks for the input. In my case I think the tail end of the...

In forum Assembly and first prints troubleshooting

7 months ago
LOL. So, instead, read "open to the rear side"

In forum Assembly and first prints troubleshooting

7 months ago
Thank you, I will search for it, and see if it's the same th...

In forum Assembly and first prints troubleshooting

7 months ago
I would say that it's purging enough, at least it the same s...

In forum Assembly and first prints troubleshooting

7 months ago
Yes, that is an obvious turnaround but if that is the only s...

In forum Assembly and first prints troubleshooting

7 months ago
Thank you for your help, but the extruder is not too hot. I'...

In forum Assembly and first prints troubleshooting

7 months ago
Join spool function leaves a huge mark

In forum Assembly and first prints troubleshooting

7 months ago
Filament tips with long strings

In forum Assembly and first prints troubleshooting

7 months ago
I do that by removing the two screws with springs from both ...

In forum Assembly and first prints troubleshooting

7 months ago
I had to cut mines because of space limitations where I have...

In forum Assembly and first prints troubleshooting

7 months ago
Share: