Notifications
Clear all
RoshyRu
Group: Registered
Joined: 2020/08/05
Active Member
1
@neophyl, I did not open that issue. @bobstro I tried renami... In forum PrusaSlicer |
4 years ago | |
@bobstro I tried that out but it still didn't work. It would... In forum PrusaSlicer |
4 years ago | |
@bobstro Here's a snippet of my config bundle. It's currentl... In forum PrusaSlicer |
4 years ago | |
@neophyl > Possibly stupid question but you are selecting... In forum PrusaSlicer |
4 years ago | |
Can't import config bundle from other computer properly In forum PrusaSlicer |
4 years ago | |
Can't import config bundle from other computer properly In forum PrusaSlicer |
4 years ago | |
After looking at it closely I did notice that it was the the... In forum Hardware, firmware and software help |
4 years ago | |
Bare wire for hotend is exposed, was rubbed off from printin... In forum Hardware, firmware and software help |
4 years ago |