Notifiche
Cancella tutti
rosenstand
rosenstand
Gruppo: Registrato
Registrato: 2019/03/17
Active Member
1
Clogging in top of organic supports

Nel forum Hardware, firmware and software help

1 year fa
@peter-c20 I use these (x 6):/p> They work really well and l...

Nel forum User mods - OctoPrint, enclosures, nozzles, ...

4 years fa
@max-distortion I’m afraid those are waaay too small/soft fo...

Nel forum User mods - OctoPrint, enclosures, nozzles, ...

5 years fa
@chocki I’m glad you’re impressed with them too 🙂 It’s craz...

Nel forum User mods - OctoPrint, enclosures, nozzles, ...

5 years fa
@chocki Neat way to measure, thanks for the tip 🙂 I would e...

Nel forum User mods - OctoPrint, enclosures, nozzles, ...

5 years fa
@chocki I would ask the seller if they’re 1,25 inch (roughly...

Nel forum User mods - OctoPrint, enclosures, nozzles, ...

5 years fa
@chocki remember to do a rough weight calculation and order ...

Nel forum User mods - OctoPrint, enclosures, nozzles, ...

5 years fa
Thanks bobstro. As I said I did run the printer on a paver f...

Nel forum User mods - OctoPrint, enclosures, nozzles, ...

5 years fa
Thanks choki, although too late for me it might be helpful f...

Nel forum User mods - OctoPrint, enclosures, nozzles, ...

5 years fa
Ok, so I finally got all parts and time to install them. I d...

Nel forum User mods - OctoPrint, enclosures, nozzles, ...

5 years fa
@chocki That’s my backup plan 🙂 I would prefer to avoid a g...

Nel forum User mods - OctoPrint, enclosures, nozzles, ...

5 years fa
@robert-rmm200 I don’t think it’s any louder than any other ...

Nel forum User mods - OctoPrint, enclosures, nozzles, ...

5 years fa
Where to get Sorbothane feet in Europe

Nel forum User mods - OctoPrint, enclosures, nozzles, ...

5 years fa
I was thinking about either adding a thin paver on top of th...

Nel forum User mods - OctoPrint, enclosures, nozzles, ...

6 years fa
Mounting on a sand bag?

Nel forum User mods - OctoPrint, enclosures, nozzles, ...

6 years fa
Thanks a lot! I was using default SlicerPE values for Prusam...

Nel forum Assembly and first prints troubleshooting

6 years fa
Failing large prints

Nel forum Assembly and first prints troubleshooting

6 years fa
Condividi: